The Curve Settings can be accessed through the Edit menu, the Control Point Settings button, or by right-clicking on the Drawing View drawing and selecting Control Points… on the pop-up menu.
A dashed line will be drawn between the PC-PT of curves and the TS-SC and CS-ST
of spirals.
The chord bearing/azimuth, distance, radius, delta and tangent are shown for
each curve. Spirals display the chord bearing/azimuth, beginning radius, ending
radius, spiral angle, spiral length and constant of proportionality.
Draws a leader line from the center of the curve/spiral to the label. The style
(line type, arrow, size) of these leaders is controled in the Drawing Settings
dialog in the Miscellaneous tab.
Choose this option to plot PIs of curves. No lines will be drawn to the PI but
it will be drawn and labeled using the Control Point Settings.
Provides direct access to the label format settings for the drawing.
These settings draw a short radius ray from the PC / PT / SC / CS points to the PR of the curve or spiral.
Turn this option on to draw the rays.
This option is not yet available.
Specify the ray length in inches.
Drawing Settings vs. Traverse Settings
Changing Control Point Settings
Personal, Premium, Professional