This option allows you to specify the leg of a control traverse that you have closed upon for an angular error check.
Enter the actual angle turned at the closing point to the reference leg. The reference leg does not have to be part of this traverse.
You cannot edit this field. It displays the computed bearing/azimuth of the closing leg based on the Closing Angle entered.
Enter the correct bearing/azimuth of the closing leg or enter an equation that defines it.
Computed as the difference between the computed and correct bearings/azimuths. This is also the amount of error that will be used to balance angles.
Note: Angles are not actually balanced until you choose Adjust | Balance Angles.
Click this button to apply your changes and return to the Closure View.
Click this button to return to the Closure View without applying your changes.